Life Science and Lab Leases Life science and laboratory leases in New York City.

Lab space is built around chemicals, air, power, and vibration, and it has to be cleaned and certified on the way out. The lease must address each before construction starts.

We represent landlords and life science companies in leases for wet labs, dry labs, and research and development space in New York City and the suburbs.

Laboratory tenants need far more from a building than office tenants: higher floor loads, vibration control for sensitive instruments, once-through ventilation with high air-change rates, exhaust stacks and fume hoods, emergency power, and plumbing for lab sinks, pure water, and acid-neutralization. Many New York buildings were not designed for that, and converted office space often needs new shafts, roof equipment, and structural work. The lease and work letter should say who pays for each.

Hazardous materials drive the permits. Under the New York City Fire Code, a non-production laboratory storing, handling, or using more than one gallon of flammable or combustible liquid, or 75 standard cubic feet of flammable gas, in a laboratory unit needs a Fire Department permit and must operate under the supervision of a C-14 certificate of fitness holder. The building code and Fire Code also limit the quantity of hazardous materials in each control area, and control areas allowed per floor decrease as you go up a building, so floor location and stacking plans matter.

Biological work is generally conducted to the biosafety level guidance of the CDC and NIH, and most commercial lab space in the City is designed for BSL-1 and BSL-2 work. Radioactive materials in New York City are licensed by the Department of Health and Mental Hygiene, and lab wastewater and generators raise separate environmental requirements.

Our capabilities include:

  • Base-building diligence for loads, shafts, and power
  • Work letters for lab buildouts
  • Hazardous materials, control areas, and FDNY permits
  • Biosafety and laboratory ventilation provisions
  • Emergency power and generator rights
  • Roof, shaft, and exhaust rights
  • Decommissioning and restoration at lease end
  • Expansion, contraction, and sublease flexibility

For landlords and tenants

Building features a lab lease must address

Floor loadLab equipment and storage often exceed office design loads; confirm capacity with an engineer
VibrationSensitive instruments need stiffer floors and isolation; define the criteria in the lease
HVAC and exhaustOnce-through air, higher air-change rates, fume hood exhaust, and roof stacks
Hazardous materialsControl-area limits by floor, FDNY permits, and C-14 supervision
PowerHigher electrical capacity and emergency or standby power for freezers and critical systems
PlumbingLab waste, acid neutralization, pure water systems, and eyewash and safety showers

Key terms in a lab lease

  • Permitted use

    Laboratory, research, and related office use, with any limits on biosafety level, animals, or radioactive materials.

  • Hazardous materials

    A tenant inventory, compliance covenant, allocated share of control-area capacity, and indemnity.

  • Building systems

    Rights to shafts, roof space, generators, and tie-ins, with landlord approval of design.

  • Operating hours

    24-hour HVAC and access, with the cost of after-hours service fixed or capped.

  • Decommissioning

    Removal of hazardous materials and a closure report from a qualified consultant before surrender.

Key terms

Wet lab
Laboratory space where chemicals, biological materials, and water are used, requiring plumbing, fume hoods, and special ventilation.
Dry lab
Laboratory space for computational, electronic, or instrument work without wet chemistry.
Floor load
The weight a floor is designed to carry, often higher for labs than for offices.
Vibration criteria
Standards limiting floor movement so sensitive instruments such as microscopes work properly.
Air changes per hour
How many times the room air is replaced each hour; labs generally require more than offices.
Once-through air
Ventilation that exhausts lab air rather than recirculating it.
Fume hood
A ventilated enclosure that captures fumes and exhausts them through the roof.
Control area
A space within a building where hazardous materials are stored or used up to code-limited quantities.
Maximum allowable quantity
The code limit on each class of hazardous material in a control area.
C-14 certificate of fitness
The FDNY certificate required for the person supervising a non-production chemical laboratory that needs a permit.
Biosafety level (BSL)
CDC and NIH containment levels for biological work, from BSL-1 to BSL-4.
Emergency power
Generator or other backup power for freezers, hoods, and life-safety systems.
Decommissioning
Removing hazardous materials and decontaminating a lab, documented in a closure report.
Work letter
The lease exhibit setting the scope, cost, schedule, and approvals for the buildout.

Questions we hear most

Can ordinary office space be converted to a wet lab?

Sometimes, but it is expensive. Floor-to-floor height, structural capacity, shaft space for exhaust and supply air, roof access, and electrical service all limit conversions, and an engineer should review the building before the letter of intent.

Who needs the FDNY laboratory permit?

The tenant operating the lab. A non-production laboratory exceeding the Fire Code thresholds for flammable and combustible liquids or flammable gas needs a permit and a C-14 certificate of fitness holder to supervise it, and the lease should require the tenant to maintain both.

What is decommissioning?

The process of removing hazardous materials, decontaminating surfaces and equipment, and documenting the space’s condition when a lab closes. Leases commonly require a report from a qualified consultant before the landlord accepts surrender.

Do you represent both landlords and life science tenants?

Yes, never on the same deal.

Is laboratory use allowed by zoning?

Research laboratories are allowed in many commercial and manufacturing districts, but it depends on the lot and the type of work. The City’s 2024 zoning changes reorganized the use regulations, so older use-group references should be checked against current zoning.

What is the difference between BSL-1 and BSL-2?

BSL-1 covers well-characterized agents not known to cause disease in healthy adults. BSL-2 covers agents of moderate hazard and adds controls such as restricted access and biosafety cabinets, which affect the design.

Can a lab go on a high floor?

It can, but the number of control areas and the quantities allowed decrease on upper floors. Stacking plans should be checked against the codes before the lease is signed.

Do labs need a generator?

Many do for freezers, incubators, and critical ventilation. Generators raise structural, fuel, and environmental permitting questions, so the lease should allocate them.

Who handles lab waste?

The tenant, through licensed contractors. The lease should require compliance with hazardous, biological, and wastewater rules and give the landlord copies of manifests on request.

Are radioactive materials allowed?

Only if the lease permits them and the tenant holds the required license, which in New York City is issued by the Department of Health and Mental Hygiene.
Contact

Get in touch

Tell us about the space, the parties, and the timing. Initial consultations are complimentary, and we provide a clear scope and fee quote at the outset.

Send an inquiry

Tell us about the matter and we will respond within one business day.

All inquiries are confidential. Initial consultation is complimentary. We will respond within one business day.

Skip to main content