Published
Not legal advice. This article is general information about New York law. Reading it does not create an attorney-client relationship. For advice about your situation, consult a lawyer.
What does NYC Local Law 23 of 2026 require?
Local Law 23 of 2026 adds a cooling requirement to the Housing Maintenance Code. Beginning March 1, 2028, tenants may elect cooling for a primary sleeping room. From June 1, 2030, owners must keep elected rooms at or below 78°F from June 15 through September 15. Violations are class C, and implementing rules have not been finalized as of November 13, 2026.
What the law does
The City Council passed Int. 994-A on December 18, 2025, and it became Local Law 23 of 2026 on January 20, 2026, without the Mayor’s signature. It adds a new section 27-2030 to the Housing Maintenance Code, which the Department of Housing Preservation and Development (HPD) enforces, and amends the Building Code’s design standard for air-conditioned spaces.
The basic structure is opt-in. Owners are not required to install cooling everywhere. Instead, a tenant may elect to have a covered room made subject to the cooling requirement, and once the obligation begins, the owner must keep that room adequately cooled during the cooling season. Where an owner already supplies cooling through an owner-controlled system, the owner must run it to provide adequate cooling to covered rooms beginning in the 2030 season.
Key dates
| January 20, 2026 | Local Law 23 becomes law |
|---|---|
| By January 1, 2028 | The agency posts the required tenant notice online; NYCHA must prepare a cooling plan |
| March 1, 2028 | Tenants may begin electing cooling for covered rooms; new leases and renewals must state who pays cooling electricity and include the notice |
| March 1, 2028 to September 1, 2029 | Owners must give the notice to tenants and post it in the building |
| June 1, 2030 | Owner cooling obligation begins; Building Code amendment applies to construction document applications filed on or after this date |
| June 1, 2031 | Annual owner inspections begin |
Some published summaries give March 30, 2028 as a start date. The enacted text uses March 1, 2028 for tenant elections, lease disclosures, and the start of the owner notice period, and we use that date here. An election takes effect 60 days after the tenant makes it, but the owner’s duty to cool does not begin before June 1, 2030.
Who and what is covered
- A covered dwelling is a multiple dwelling, or a tenant-occupied one- or two-family house. Multiple dwellings used by the City for emergency temporary housing are excluded.
- A covered room is a room the owner knows is used, or that is foreseeably used, as the primary sleeping place of a permanent occupant.
- For a condominium unit, the responsible owner is the unit owner. For a cooperative apartment, it is the shareholder of record on the proprietary lease. A co-op shareholder or condo owner who rents out the apartment therefore carries the obligation for that unit.
- Because the duty is triggered by a tenant’s election, an apartment occupied by its owner generally will not be affected.
- NYCHA is on a separate track under a cooling plan, with its own interim targets.
The standard, and how it is enforced
Adequate cooling means cooling sufficient to keep the indoor air at or below 78°F, measured at least three feet above the floor and three feet from any exterior wall, during the cooling season of June 15 through September 15. The agency may adjust the standard by rule if it is not technologically feasible. Some summaries describe an outdoor-temperature trigger; the enacted text we reviewed sets the indoor standard and the season without one, and the rules may address how compliance is measured.
A non-central system qualifies as an approved cooling system if it has at least 20 BTU per hour of capacity for each square foot of the area it serves, subject to exceptions set by rule or Department of Buildings approval. Centrally supplied systems must meet a capacity standard the Department of Buildings will set by rule. An approved system is presumed capable of adequate cooling, subject to the rules.
A violation of the cooling, notice, or inspection requirements is a class C immediately hazardous violation, and the owner has 14 days after service of the notice of violation to correct it. The agency may extend an owner’s time to comply, in increments of up to two years, for undue hardship such as financial hardship, major capital work, significant electrical upgrades, or landmark status, where a permanent system is impracticable to install, or while the owner negotiates City financial assistance.
As of November 13, 2026, we have not seen final rules implementing the law. Expect rules on measurement, approved systems, notices, inspections, and extensions before the 2028 dates arrive.
Rent-regulated units and cost recovery
For a rent-regulated unit, the cooling obligation applies only if the tenant has consented to the improvements needed to provide adequate cooling and to any associated charges, in a manner consistent with state law and regulations. The notice must tell tenants that installing a new cooling system in a rent-regulated unit, or in a building containing one, may increase the unit’s regulated rent.
The local law does not create its own rent increase. Whether an owner can recover the cost depends on state rent law and DHCR rules. Equipment installed inside an occupied apartment may qualify as an individual apartment improvement, which requires the tenant’s written consent and is subject to statutory caps. A building-wide system may qualify for a major capital improvement increase, which requires DHCR approval and is subject to an annual cap. Neither is automatic, and the documentation requirements are strict.
For market-rate units, cost allocation is a lease issue. Beginning March 1, 2028, every new lease and renewal must say who pays the electricity to run the cooling system, so lease forms should be updated before then.
Local Law 97, electrical capacity, and capital planning
Cooling adds electrical load at the same time Local Law 97’s emissions limits tighten for the 2030–2034 compliance period. Owners planning for both should consider them together. Heat pumps can provide both heating and cooling and may help with emissions compliance, while window or through-wall units are quicker to install but add load without addressing heating emissions.
- Have an engineer assess electrical service, risers, and apartment panels, since an upgrade or new utility service can take a long time to plan and complete.
- Check whether sleeve, window, or fire escape constraints affect where units can go. The law does not require cooling equipment where it would conflict with fire code requirements for fire escapes.
- For landmarked buildings, factor in Landmarks Preservation Commission review of through-wall and rooftop equipment.
- Align cooling work with Local Law 97 planning, capital budgets, and any financing or incentive applications.
- Co-op and condo boards should review alteration agreements and house rules, since shareholders and unit owners who rent out apartments will need to install or permit equipment.
We represent owners, boards, and investors in Housing Maintenance Code compliance, HPD violations, DHCR increase applications, and the lease and alteration documents that compliance requires.
Not legal advice. This article is general information about New York law as of the date above. It is not legal advice, may not reflect later changes, and does not create an attorney-client relationship. Attorney advertising.